Watchguard V2 Especificações descarregar pdf (Página 28)

4.5. Walk Test Mode

Walk test mode should be used when testing the system or after a new detector has

been learnt into the system.

TO ENTER WALK TEST MODE

Safety Lock must

be off

Ensure Safety Lock has been turned off within the last 5

minutes. See Section 4.2.

Press both buttons

for 3 seconds

Enter Programming mode by pressing buttons 1 & 2

together for 3 seconds. The siren will beep 3 times to

confirm you have entered programming mode.

Press 1 time

Within 3 seconds, press Button 2 to select special

features. You will hear 2 beeps as confirmation.

Press 1 time

Within 30 seconds, press Button 2 to enter Walk Test

mode. You will hear 2 beeps as confirmation.

Walk Test mode

The system will enter Walk Test mode. During this time,

the siren will beep the number of times of the zone which

has been triggered. Detectors which have been set to 24

hour mode will still trigger the alarm. If the tamper switch

is pressed the siren will beep once.

Press 1 time to exit

Press Button 2 to exit Walk Test mode.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 39 40

Sem comentários

Watchguard V2 Especificações Página 28